Insulation Before & After in Paradise, NV
Pictures of an attic or a crawl space tell you more than any brochure. You can see where the old fiberglass had settled to four inches, where moisture was wicking up a stem wall, where daylight showed through the ceiling plane. Here’s a look at the kinds of transformations we do across Paradise, and what the difference actually looks like before we leave the driveway.
Recent Transformations
Attic Insulation Upgrade: From Six Inches to a Full Blanket


The problem: wind-driven dust had compressed the original fiberglass down to about six inches in the older single-story homes we see near Paradise Park, so the highest room on the thermostat never stayed even. We pulled the old material, air-sealed penetrations and top plates, then blew Owens Corning fiberglass to a full, uniform depth. The bedrooms upstairs reached set temperature faster after that, and the cooling cycle stopped running into the evening.
Crawl Space Encapsulation: A Vapor Barrier That Stays Put


The problem: a dirt floor and a barrier that had torn free of the stem wall, letting ground moisture come straight up into the joists (a common sight in Paradise crawl spaces where the soil stays damp near the flood-irrigated lots off Eastern Avenue). We removed the failed plastic, cleaned and sealed the space, then installed a vapor barrier with continuous taped seams and a tight wrap to the foundation wall. The floor no longer sweated, and the musty smell that had crept up from the crawl stopped showing up in the living room.
Spray Foam Insulation: Foam That Closes Gaps Fiberglass Misses


The problem: fiberglass batts in the cantilever and garage-ceiling area had gaps you could see light through, and the rooms above ran hotter than the rest of the house in July. We used Icynene spray foam to seal and insulate those cavities in one pass, so both the air leak and the weak spot got addressed together. The upstairs bedrooms stopped cycling 5 degrees behind the rest of the house.
Radiant Barrier: Cutting the Heat Off the Roof Deck


The problem: attic temperatures near 140 degrees on a summer afternoon with the barrier not much more than bare sheathing, and return ducts pulled tight against that heat. We installed a radiant barrier along the underside of the roof rafters, keeping soffit and ridge venting clear. The attic ran cooler, the AC stopped working against a radiator overhead, and the electric bill stepped down through the summer months that followed.
Insulation Removal and Rodent Proofing: A Clean Start


The problem: insulation that had been tunneled through, soiled, and flattened to almost nothing, plus gaps along the eaves where rodents were getting back in. We removed the old material, cleaned and disinfected the attic, sealed the openings, and installed fresh Johns Manville insulation. The scratching in the ceiling stopped, and the room below held temperature through the night again.
Attic Air Sealing: Stopping the Drafts First


The problem: a home that felt drafty even after a fresh layer of insulation, because conditioned air was leaking straight through unsealed can lights and top plates. We tracked the leaks with a home energy audit, sealed the penetrations with rated materials, then relied on GreenFiber blown-in insulation to finish the job. The drafts quit, and the thermostat started holding its setting instead of chasing a moving target.
Want Results Like These?
If your attic or crawl space looks anything like these before shots, we can take a look and show you what a fix would involve. Call Walt’s Insulation Paradise at (844) 978-0556 – the phones are answered by a live person 24/7, and there’s no trip charge inside our county. Estimates are upfront, and the Done Right Promise backs every job for life.
Written by the team at Walt’s Insulation Paradise.